|
|
|
 |
 |
|
|
|
|
PCB Drying Machine,
The stainless steel bench top printed circuit board drying
machine processes wet circuit boards through a series of squeegee towelling
rollers and a heated air knife to fully dry them. The unit consists of four
pairs of squeegee towelling rollers, the first pair rotate in a shallow water
tank with a water level detector, this pair helps to remove capillary water
trapped in the drilled holes. The second and third pair of rollers remove excess
moisture before the circuit board enters the heat zone where the high output
blower air knife removes moisture from both surfaces of the board and from
inside the holes. The board then exits through the last pair of rollers dry. The
electronic control module allows the operator choice of two heat settings with
variable circuit board feed rates through the machine thus giving optimum drying
rates. The unit has an automatic over-run switch which operates the wet squeegee
rollers at a maximum speed and runs with the heaters for approximately ten
minutes to part dry the rollers for future use.
| Specification |
|
| Maximum panel width |
610 mm ( 24 inches ) |
| Number of towelling rollers |
8 |
| Power requirements |
220/240 volts 50 Hz @ 13 amps |
| Heaters |
Two (1500 watts each) |
| Motor Speed |
0 - 5 metres/min. |
| Capillary tank capacity |
500 millilitres |
| Dimensions |
840 mm x 370 mm x 380 mm High |
| Shipping Dimensions |
900 mm x 430 mm x 510 mm High |
| Weight |
62 Kgs |
| Shipping Weight |
70 Kgs |
|
Fortex, 15-17 Fleetwood Rd, Leicester, LE2 1YA, England
Tel: +44 (0) 116 2708 937 - Fax: +44 (0) 116 2700 532 - Email: sales@fortex.co.uk
|
|
|
|
|
| © 2005 Fortex / PC Drills Limited, All Rights Reserved - Web site designed by Opem Solutions. |
|
|
